Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
On Mon, Jan 04, 2010 at 03:19:23PM +0000, Sven Geggus wrote: > Hello, > > I've got two Problems in my effort to upgrade an older installation (debian > etch/drbd 8.0.14) to a more recent Version (debian etch with kernel > 2.6.32.2 and drbd 8.3.7rc1). I'm going for the rc1 Version since 8.3.6 does > not seem to compile on 2.6.32.x. > > Unfortunately this does not work at all: > > 1. Problem: > Debian Package does not build: > ... > config.status: error: cannot find input file: user/config.h.in run autoheader once > 2. When installing manually from the tarball I get a more serious Problem > afterwords: > > ~/ # drbdadm attach all > 0: Failure: (111) Low.dev. smaller than requested DRBD-dev. size. > Command 'drbdsetup 0 disk /dev/sda3 /dev/sda3 internal --set-defaults --create-device --on-io-error=detach' terminated with exit code 10 > > dmesg shows the following: > block drbd0: Starting worker thread (from cqueue [6849]) > block drbd0: ==> truncating very big lower level device to currently maximum possible 4294967295 sectors <== > block drbd0: disk( Diskless -> Attaching ) > block drbd0: refusing to truncate a consistent device > block drbd0: disk( Attaching -> Diskless ) > block drbd0: drbd_bm_resize called with capacity == 0 > block drbd0: worker terminated > block drbd0: Terminating worker thread > > This _did_ work bevore with the older Kernel using drbd 8.0.14 well, and it seems it does work for us, too. maybe you misconfigured your new kernel? > Any hint on how to fix this? how about enable large block devices in your kernel? hey, just asking... you know, sometimes it is just too easy to see :) -- : Lars Ellenberg : LINBIT | Your Way to High Availability : DRBD/HA support and consulting http://www.linbit.com DRBD® and LINBIT® are registered trademarks of LINBIT, Austria. __ please don't Cc me, but send to list -- I'm subscribed