Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
FYI i also get this via console or dmesg martian source xx.xx.xx.150 from 192.168.1.8, on dev eth1 ll header: 00:15:8a:00:2c:2c:00:03:6c:fc:06:c0:08:00 i have never seen that in my life before? .150 is my primary public IP eth1 :) Rob Morin Dido Internet Inc. Montreal,Canada http://www.dido.ca 514-990-4444 Rob Morin wrote: > I created the private lan just for drbd, each private lan goes to a > vlan on a switch that consists of 2 ports only.... > > also as a note, i had someone mention to me that my eth0 or private ip > address setup should not have a gateway as to not affect the public > lan.. so my /etc/network/interfaces file looks like this.. > > > iface eth0 inet static > address 192.168.1.149 > netmask 255.255.255.0 > > > is that ok > > Rob Morin > Dido Internet Inc. > Montreal,Canada > http://www.dido.ca > 514-990-4444 > > > > rois wrote: >> On Mon, 2008-02-18 at 14:52 -0500, Rob Morin wrote: >> >>> OK so i am using 2 NICS eth0 for 192.168.1.x and eth1 for my public IP >>> >>> now when we add the 2 nodes in each servers /etc/hosts file do i use >>> the private ip or the public one, drbd use the 192 for heartbeat and >>> replication.... >>> >> Well I wouldn't put the replication link in the public. Is the private >> a private lan accessing the server or just a crossover/drbd link? >> >> I have a server with a public lan and a private lan so I added a 3rd nic >> with a crossover cable just for drbd replication. Then heartbeat uses >> the public and private but not the crossover. >> >> >> _______________________________________________ >> drbd-user mailing list >> drbd-user at lists.linbit.com >> http://lists.linbit.com/mailman/listinfo/drbd-user >> > _______________________________________________ > drbd-user mailing list > drbd-user at lists.linbit.com > http://lists.linbit.com/mailman/listinfo/drbd-user