Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
With protocol A that does not make a lot of sense. So using the lowlevel device directly in stead of the DRBD resource gives you a noticeable performance boost? On Tuesday 08 June 2010 12:52:25 Gerry Kernan wrote: > Hi > > Yes sync is ok. And both resources are consistent. But some processes that > access the drbd resource are taking longed that before i enabled the > resources > > Gerry > > > > -----Original Message----- > From: drbd-user-bounces at lists.linbit.com > [mailto:drbd-user-bounces at lists.linbit.com] On Behalf Of Bart Coninckx > Sent: 08 June 2010 09:40 > To: drbd-user at lists.linbit.com; Gerry Kernan > Subject: Re: [DRBD-user] slow preformance to remote server > > On Thursday 03 June 2010 16:10:18 Gerry Kernan wrote: > > Hi > > > > I have a 2 drbd resources setup to run to a remote servervia a 35Mb > > wireless link. I am using prococol A and sync rate of 35M, are thereany > > other setting i can use to try and improve performance. Since turning > > ondrbd users on the system are complaining that process are taking > > longer to run. > > > > Thanks in advance > > > > > > Regards, > > Gerry Kernan > > InfinityIT > > > > Suite 17 The Mall, > > Beacon court, > > Sandyford, > > Dublin 18. > > > > p:+353-1-2930090 > > f:+353-1-2930137 > > If you use a sync rate of 35MB/sec the complete bandwidth will be used in > case of a sync. Is a sync happening? > > B. > _______________________________________________ > drbd-user mailing list > drbd-user at lists.linbit.com > http://lists.linbit.com/mailman/listinfo/drbd-user >