[DRBD-user] DRBD - on ARM (armel)

Philipp Reisner philipp.reisner at linbit.com
Wed Jun 17 10:34:04 CEST 2009

Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.


On Tuesday 16 June 2009 23:49:10 Nick Liebmann wrote:
> Hi Philipp,
>
> I have spent a bit more time looking into this. I am now working from
> the latest version of the git repository, which seems to have had your
> changes applied.
>
> I have gone back to basics, since I was concered I was feeding you
> mis-information.

[...]

Please correct me if I got something wrong:
* You used the latest sources from GIT
* If you use the "drbdadm up" command you get 

0: Failure: (126) UnknownMandatoryTag
 Command 'drbdsetup 0 net XXX.XXX.XXX.XXX:7788 XXX.XXX.XXX.XXX:7788 C
 --set-defaults --create-device --allow-two-primaries
 --after-sb-0pri=discard-zero-changes --after-sb-1pri=discard-secondary
 --after-sb-2pri=disconnect' terminated with exit code 10

Jun 16 22:34:20 nasty kernel: block drbd0: Unknown tag: 3526


* If you use the drbdsetup commands one by one, it works.

That does not feel like an alignment issue, that feels more like a
race condition.

-Phil
-- 
: Dipl-Ing Philipp Reisner
: LINBIT | Your Way to High Availability
: Tel: +43-1-8178292-50, Fax: +43-1-8178292-82
: http://www.linbit.com

DRBD(R) and LINBIT(R) are registered trademarks of LINBIT, Austria.




More information about the drbd-user mailing list