Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
On Thu, Oct 16, 2008 at 12:04:19PM -0700, Jeffrey Froman wrote: > > I have a drbd resource that appears to be working correctly. However, > when I run "drbdadm -d adjust <resource>" (without changing the > working configuration), I get: > > 286744120s: out of range > > This number is the configured size of the drbd disk (see drbd.conf > below), but: > > [root ~]# blockdev --getsize /dev/sdc1 > 286744122 > > So why am I getting an "out of range" error for an otherwise seeminly > working resource? > > Thank you, > Jeffrey you normally should not use that config parameter. since we almost never do, we did not notice yet that there is a bug in the 's' unit conversion. simple fix: just DO NOT explicitly set a size. it is only useful in very special cases if at all. -- : Lars Ellenberg : LINBIT | Your Way to High Availability : DRBD/HA support and consulting http://www.linbit.com DRBD® and LINBIT® are registered trademarks of LINBIT, Austria. __ please don't Cc me, but send to list -- I'm subscribed