Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
Certainly I could be wrong, but this could be the limit of my hard
drives in general...
Probably answered this myself :)
THANKS!
On Tue, 2005-04-19 at 12:08 -0600, Vasiliy Boulytchev wrote:
> Ladies and Gents,
> I have a crossover cable running between two gig E cards. dmesg shows
> that both nics come up with full duplex 1000 mode. when doing a resync,
> i get this performance:
>
>
> 0: cs:SyncTarget st:Secondary/Primary ld:Inconsistent
> ns:0 nr:4110400 dw:4110400 dr:0 al:0 bm:6202 lo:345 pe:1835 ua:345
> ap:0
> [>...................] sync'ed: 4.3% (91206/95218)M
> finish: 0:33:21 speed: 46,592 (19,660) K/sec
>
>
> What am I doing wrong?
>
> Here is my drbd.conf
>
>
>
> resource r0 {
> protocol C;
> incon-degr-cmd "echo '!DRBD! pri on incon-degr' | wall ; sleep
> 60 ; halt -f";
> startup {
> wfc-timeout 10; degr-wfc-timeout 120;
> }
> disk {
> on-io-error detach;
> }
> net {
> timeout 60;
> connect-int 10;
> ping-int 10;
> #max-buffers 2048;
> max-epoch-size 2048;
> }
> syncer {
> rate 100M;
> group 1;
> #al-extents 257;
> }
>
> on box1 {
> device /dev/drbd0;
> disk /dev/hda4;
> address 192.168.30.30:7788;
> meta-disk internal;
> }
>
> on box2 {
> device /dev/drbd0;
> disk /dev/hda4;
> address 192.168.30.31:7788;
> meta-disk internal;
> }
> }
>
>
> THANKS!
>
>
> _______________________________________________
> drbd-user mailing list
> drbd-user at lists.linbit.com
> http://lists.linbit.com/mailman/listinfo/drbd-user
--
-------------
Vasiliy Boulytchev
Colorado Information Technologies Inc.
http://www.coinfotech.com