Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
I'm running 0.7pre7 2004/06/01. The (initial) primary is an FC2 2.6.5 and runs fine, save for eventually noting that the connection to the secondary was lost. The secondary is a FC1 2.4.22 machine and loads the module fine, but shortly after starting to sync I get several oops (see attached). After this happens /proc/drbd shows a connection state of NetworkFailure and the modules used count is at 1. I tried to 'drbdadm disconnect..' (hoping to follow with a detach and rmmod), which results in another oops and drbd's used count jumping to 3. Needless to say, I'm left to reboot the machine. I'm using 100MB NICs (in half duplex) and have noticed that if I drop the sync rate to 1MB or less it seems fine for longer than the usual ten seconds. I've only just started a sync at 500k, and at this rate I'll know some time tomorrow (barring an oops) if it's actually succeeded. With regards, Tom Howell-Cintron P.S. Is attaching the oops the best way to go? I figured it'd get mangled when it wrapped if I did it in-line.. -------------- next part -------------- An embedded and charset-unspecified text was scrubbed... Name: 0_7_pre7_20040601_oops_on_2_4_22.txt URL: <http://lists.linbit.com/pipermail/drbd-user/attachments/20040605/6dc2f5ae/attachment.txt>