Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
W dniu 01.06.2016 o 12:39, Simon Ironside pisze: > On 01/06/16 11:14, For at ll wrote: > >> cat /proc/drbd >> version: 8.3.7 (api:88/proto:86-91) >> srcversion: EE47D8BF18AC166BE219757 >> 0: cs:WFConnection ro:Secondary/Unknown ds:Consistent/DUnknown C r---- >> ns:0 nr:0 dw:0 dr:0 al:0 bm:0 lo:0 pe:0 ua:0 ap:0 ep:1 wo:b oos:0 >> 1: cs:WFConnection ro:Secondary/Unknown ds:Consistent/DUnknown C r---- >> ns:0 nr:0 dw:0 dr:0 al:0 bm:0 lo:0 pe:0 ua:0 ap:0 ep:1 wo:b oos:0 >> 2: cs:WFConnection ro:Secondary/Unknown ds:Consistent/DUnknown C r---- >> ns:0 nr:0 dw:0 dr:0 al:0 bm:0 lo:0 pe:0 ua:0 ap:0 ep:1 wo:b oos:0 >> >> I try change it to the primary with force but I get error message: >> >> drbdadm primary --force r2 >> 2: State change failed: (-2) Refusing to be Primary without at least one >> UpToDate disk >> Command 'drbdsetup 2 primary' terminated with exit code 17 > > I think you're trying to use a DRBD 8.4 command with an 8.3 install. Try > this instead: > > drbdadm -- -o primary r2 > > HTH, > Simon. Hi Simon, Effect is the same.... drbdadm -- -o primary r2 2: State change failed: (-2) Refusing to be Primary without at least one UpToDate disk Command 'drbdsetup 2 primary -o' terminated with exit code 17