Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
On 02/25/2016 03:14 PM, Eric Robinson wrote: > > I have a 2-node cluster, where each node is primary for one drbd > volume and secondary for the other node’s drbd volume. Replication is > A->B for drbd0 and A<-B for drbd1. I have a logical volume and > filesystem on each drbd device. When I try to failover resources, the > filesystem fails to mount because lvdisplay shows the logical volume > is listed as “not available” on the target node. Is there some trick > to getting LVM on DRBD to fail over properly? > Your situation is very much like you have "use_lvmetad = 1" in you lvm.conf. You must change it to "0" to disable lvmetad. That said, lvmetad is not cluster aware. Cheers, Roger > -- > > Eric Robinson > > > > _______________________________________________ > drbd-user mailing list > drbd-user at lists.linbit.com > http://lists.linbit.com/mailman/listinfo/drbd-user -- regards, Zhou, ZhiQiang (Roger) (office#:+86 10 65339283, cellphone# +86 13391978086) -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.linbit.com/pipermail/drbd-user/attachments/20160226/9dc06994/attachment.htm>