Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
Add and remove space as per coding style for loops,comma , open and close
parenthesis.It also removes whitespace.
This patch is to the ataflop.c file that fixes up following ERRORs
reported by checkpatch:
- space prohibited before that close parenthesis ')'
- space prohibited after that open parenthesis '('
- trailing whitespace
- space required after that ',' (ctx:VxV)
- spaces required around that '=' (ctx:VxW)
- space required before the open parenthesis '('
Signed-off-by: Punit Vara <punitvara at gmail.com>
---
drivers/block/ataflop.c | 82 ++++++++++++++++++++++++-------------------------
1 file changed, 41 insertions(+), 41 deletions(-)
diff --git a/drivers/block/ataflop.c b/drivers/block/ataflop.c
index 2104b1b..3cd50a8 100644
--- a/drivers/block/ataflop.c
+++ b/drivers/block/ataflop.c
@@ -1710,12 +1710,12 @@ static void __init fd_probe( int drive )
UD.connected = 0;
UDT = NULL;
- if (!fd_test_drive_present( drive ))
+ if (!fd_test_drive_present(drive))
return;
UD.connected = 1;
UD.track = 0;
- switch( UserSteprate[drive] ) {
+ switch(UserSteprate[drive]) {
case 2:
UD.steprate = FDCSTEP_2;
break;
@@ -1729,7 +1729,7 @@ static void __init fd_probe( int drive )
UD.steprate = FDCSTEP_12;
break;
default: /* should be -1 for "not set by user" */
- if (ATARIHW_PRESENT( FDCSPEED ) || MACH_IS_MEDUSA)
+ if (ATARIHW_PRESENT(FDCSPEED) || MACH_IS_MEDUSA)
UD.steprate = FDCSTEP_3;
else
UD.steprate = FDCSTEP_6;
@@ -1748,46 +1748,46 @@ static void __init fd_probe( int drive )
* declared absent.
*/
-static int __init fd_test_drive_present( int drive )
+static int __init fd_test_drive_present(int drive)
{
unsigned long timeout;
unsigned char status;
int ok;
-
- if (drive >= (MACH_IS_FALCON ? 1 : 2)) return( 0 );
- fd_select_drive( drive );
+
+ if (drive >= (MACH_IS_FALCON ? 1 : 2)) return(0);
+ fd_select_drive(drive);
/* disable interrupt temporarily */
- atari_turnoff_irq( IRQ_MFP_FDC );
+ atari_turnoff_irq(IRQ_MFP_FDC);
FDC_WRITE (FDCREG_TRACK, 0xff00);
- FDC_WRITE( FDCREG_CMD, FDCCMD_RESTORE | FDCCMDADD_H | FDCSTEP_6 );
+ FDC_WRITE(FDCREG_CMD, FDCCMD_RESTORE | FDCCMDADD_H | FDCSTEP_6);
timeout = jiffies + 2*HZ+HZ/2;
while (time_before(jiffies, timeout))
if (!(st_mfp.par_dt_reg & 0x20))
break;
- status = FDC_READ( FDCREG_STATUS );
+ status = FDC_READ(FDCREG_STATUS);
ok = (status & FDCSTAT_TR00) != 0;
/* force interrupt to abort restore operation (FDC would try
* about 50 seconds!) */
- FDC_WRITE( FDCREG_CMD, FDCCMD_FORCI );
+ FDC_WRITE(FDCREG_CMD, FDCCMD_FORCI);
udelay(500);
- status = FDC_READ( FDCREG_STATUS );
+ status = FDC_READ(FDCREG_STATUS);
udelay(20);
if (ok) {
/* dummy seek command to make WP bit accessible */
- FDC_WRITE( FDCREG_DATA, 0 );
- FDC_WRITE( FDCREG_CMD, FDCCMD_SEEK );
- while( st_mfp.par_dt_reg & 0x20 )
+ FDC_WRITE(FDCREG_DATA, 0);
+ FDC_WRITE(FDCREG_CMD, FDCCMD_SEEK);
+ while (st_mfp.par_dt_reg & 0x20)
;
- status = FDC_READ( FDCREG_STATUS );
+ status = FDC_READ(FDCREG_STATUS);
}
- atari_turnon_irq( IRQ_MFP_FDC );
- return( ok );
+ atari_turnon_irq(IRQ_MFP_FDC);
+ return(ok);
}
@@ -1795,7 +1795,7 @@ static int __init fd_test_drive_present( int drive )
* floppies, additionally start the disk-change and motor-off timers.
*/
-static void __init config_types( void )
+static void __init config_types(void)
{
int drive, cnt = 0;
@@ -1804,30 +1804,30 @@ static void __init config_types( void )
dma_wd.fdc_speed = 0;
printk(KERN_INFO "Probing floppy drive(s):\n");
- for( drive = 0; drive < FD_MAX_UNITS; drive++ ) {
- fd_probe( drive );
+ for (drive = 0; drive < FD_MAX_UNITS; drive++) {
+ fd_probe(drive);
if (UD.connected) {
printk(KERN_INFO "fd%d\n", drive);
++cnt;
}
}
- if (FDC_READ( FDCREG_STATUS ) & FDCSTAT_BUSY) {
+ if (FDC_READ(FDCREG_STATUS) & FDCSTAT_BUSY) {
/* If FDC is still busy from probing, give it another FORCI
* command to abort the operation. If this isn't done, the FDC
* will interrupt later and its IRQ line stays low, because
* the status register isn't read. And this will block any
* interrupts on this IRQ line :-(
*/
- FDC_WRITE( FDCREG_CMD, FDCCMD_FORCI );
+ FDC_WRITE(FDCREG_CMD, FDCCMD_FORCI);
udelay(500);
- FDC_READ( FDCREG_STATUS );
+ FDC_READ(FDCREG_STATUS);
udelay(20);
}
-
+
if (cnt > 0) {
start_motor_off_timer();
- if (cnt == 1) fd_select_drive( 0 );
+ if (cnt == 1) fd_select_drive(0);
start_check_change_timer();
}
}
@@ -1843,7 +1843,7 @@ static int floppy_open(struct block_device *bdev, fmode_t mode)
struct atari_floppy_struct *p = bdev->bd_disk->private_data;
int type = MINOR(bdev->bd_dev) >> 2;
- DPRINT(("fd_open: type=%d\n",type));
+ DPRINT(("fd_open: type=%d\n", type));
if (p->ref && p->type != type)
return -EBUSY;
@@ -1900,12 +1900,12 @@ static void floppy_release(struct gendisk *disk, fmode_t mode)
}
static const struct block_device_operations floppy_fops = {
- .owner = THIS_MODULE,
- .open = floppy_unlocked_open,
- .release = floppy_release,
- .ioctl = fd_ioctl,
- .check_events = floppy_check_events,
- .revalidate_disk= floppy_revalidate,
+ .owner = THIS_MODULE,
+ .open = floppy_unlocked_open,
+ .release = floppy_release,
+ .ioctl = fd_ioctl,
+ .check_events = floppy_check_events,
+ .revalidate_disk = floppy_revalidate,
};
static struct kobject *floppy_find(dev_t dev, int *part, void *data)
@@ -1926,7 +1926,7 @@ static int __init atari_floppy_init (void)
/* Amiga, Mac, ... don't have Atari-compatible floppy :-) */
return -ENODEV;
- if (register_blkdev(FLOPPY_MAJOR,"fd"))
+ if (register_blkdev(FLOPPY_MAJOR, "fd"))
return -EBUSY;
for (i = 0; i < FD_MAX_UNITS; i++) {
@@ -2004,26 +2004,26 @@ static int __init atari_floppy_setup(char *str)
return 0;
str = get_options(str, 3 + FD_MAX_UNITS, ints);
-
+
if (ints[0] < 1) {
- printk(KERN_ERR "ataflop_setup: no arguments!\n" );
+ printk(KERN_ERR "ataflop_setup: no arguments!\n");
return 0;
}
else if (ints[0] > 2+FD_MAX_UNITS) {
- printk(KERN_ERR "ataflop_setup: too many arguments\n" );
+ printk(KERN_ERR "ataflop_setup: too many arguments\n");
}
if (ints[1] < 0 || ints[1] > 2)
- printk(KERN_ERR "ataflop_setup: bad drive type\n" );
+ printk(KERN_ERR "ataflop_setup: bad drive type\n");
else
DriveType = ints[1];
if (ints[0] >= 2)
UseTrackbuffer = (ints[2] > 0);
- for( i = 3; i <= ints[0] && i-3 < FD_MAX_UNITS; ++i ) {
+ for (i = 3; i <= ints[0] && i-3 < FD_MAX_UNITS; ++i) {
if (ints[i] != 2 && ints[i] != 3 && ints[i] != 6 && ints[i] != 12)
- printk(KERN_ERR "ataflop_setup: bad steprate\n" );
+ printk(KERN_ERR "ataflop_setup: bad steprate\n");
else
UserSteprate[i-3] = ints[i];
}
@@ -2047,7 +2047,7 @@ static void __exit atari_floppy_exit(void)
unregister_blkdev(FLOPPY_MAJOR, "fd");
del_timer_sync(&fd_timer);
- atari_stram_free( DMABuffer );
+ atari_stram_free(DMABuffer);
}
module_init(atari_floppy_init)
--
2.5.3