[DRBD-user] incompatible after-sb-0pri settings

Felix Frank ff at mpexnet.de
Fri Sep 21 16:58:50 CEST 2012

Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.


On 09/21/2012 04:52 PM, Lonni J Friedman wrote:
> I just discovered that if I run 'drbdadm adjust r0' on the primary a
> second time, after running it on the secondary, that fixes everything.
>  Did I misunderstand, and perhaps the command needs to be run first on
> the secondary, and then on the primary last?

No, that's fine. The thing is: Your nodes do break apart once you adjust
the settings on one of them. It's not a problem per se.

After adjusting the other, reconnection is trivial (but needs doing).



More information about the drbd-user mailing list