Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
Hi
I installed 8.4.1 drdb.
The cluster operates on a primary/primary mode.
However, the drives are mounted in the mode of read-only
[root at noc-1-m77 /]# cat /proc/drbd
version: 8.4.1 (api:1/proto:86-100)
GIT-hash: 91b4c048c1a0e06777b5f65d312b38d47abaea80 build by
root at noc-1-synt.rutube.ru, 2012-03-14 10:05:49
0: cs:Connected ro:Primary/Primary ds:UpToDate/UpToDate C r-----
^^
ns:0 nr:0 dw:0 dr:664 al:0 bm:0 lo:0 pe:0 ua:0 ap:0 ep:1 wo:b oos:0
Why not activate the read-write mode?
Config:
[root at noc-1-synt /]# cat /etc/drbd.d/r0.res
# create new
resource r0 {
startup {
wfc-timeout 20;
degr-wfc-timeout 10;
# we will keep this commented until tested successfully:
become-primary-on both;
}
net {
protocol C;
allow-two-primaries;
after-sb-0pri discard-zero-changes;
after-sb-1pri discard-secondary;
after-sb-2pri disconnect;
}
# DRBD device
device /dev/drbd0;
# phisical device
disk /dev/vg_noc1synt/lv02;
meta-disk internal;
on noc-1-synt.rutube.ru {
# IP address:port
address 10.1.20.10:7788;
}
on noc-1-m77.rutube.ru {
address 10.2.20.9:7788;
}
}
[root at noc-1-synt /]#
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.linbit.com/pipermail/drbd-user/attachments/20120315/f0db5440/attachment.htm>