Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
Hello, On 01/17/2012 04:22 PM, Benjamin Knoth wrote: > Hello, > > Am 17.01.2012 15:36, schrieb Andreas Kurz: >> On 01/17/2012 03:02 PM, Benjamin Knoth wrote: >>> Hello Andreas, >>> >>> Am 17.01.2012 14:51, schrieb Andreas Kurz: >>>> Hello, >>>> >>>> On 01/16/2012 11:05 AM, Benjamin Knoth wrote: >>>>> Hello, >>>>> i think it's clear and the pacemaker config is also clear but i can't >>>>> get a positiv result. >>>>> >>>>> I started with 4 maschines >>>>> >>>>> vm01 vm02 vm03 vm04 >>>>> >>>>> On vm01 and vm02 i created a DRBD resource with this config. >>>>> >>>>> resource test { >>>>> device /dev/drbd3; >>>>> meta-disk internal; >>>>> disk /dev/vg01/test; >>>>> protocol C; >>>>> >>>>> >>>>> syncer{ >>>>> rate 800M; >>>>> } >>>>> >>>>> on vm01 { >>>>> address 10.10.255.12:7003; >>>>> } >>>>> >>>>> on vm02 { >>>>> address 10.10.255.13:7003; >>>>> } >>>>> } >>>>> >>>>> On vm03 and vm04 i created this DRBD Resource >>>>> >>>>> resource test2 { >>>>> device /dev/drbd3; >>>>> meta-disk internal; >>>>> disk /dev/vg01/test; >>>>> protocol C; >>>>> >>>>> >>>>> syncer{ >>>>> rate 800M; >>>>> } >>>>> >>>>> on vm03 { >>>>> address 10.10.255.14:7003; >>>>> } >>>>> >>>>> on vm04 { >>>>> address 10.10.255.15:7003; >>>>> } >>>>> } >>>>> >>>>> This two unstacked resources are running. >>>>> >>>>> If i look in the documentation i think that i need to create the >>>>> following DRBD Resource on vm01-04. >>>>> >>>>> resource stest { >>>>> protocol A; >>>>> stacked-on-top-of test2 { >>>>> device /dev/drbd13; >>>>> address 10.10.255.16:7009; >>>>> } >>>>> stacked-on-top-of test { >>>>> device /dev/drbd13; >>>>> address 10.10.255.17:7009; >>>>> } >>>>> } >>>>> >>>>> But if i save this and copy them to all vms i get on vm03-04 if i run >>>>> drbdadm --stacked create-md stest >>>> >>>> Use the same, complete config on all nodes. >>> I copied this config on all nodes. >> >> And still not working? Can you provide or pastebin "drbdadm dump all" >> and "cat /proc/drbd" from a node that gives you that error? > > on vm01 and vm02 i get for resource test on cat /proc/drbd. The not > stacked resource works > > 3: cs:Connected ro:Primary/Secondary ds:UpToDate/UpToDate C r----- > ns:1077644 nr:0 dw:33232 dr:1044968 al:13 bm:63 lo:0 pe:0 ua:0 ap:0 > ep:1 wo:b oos:0 > > After i copied the config with resource stest to all 4 nodes i get the > following on vm01 and vm02. > > drbdadm dump all > > drbd.d/stest.res:1: in resource stest, referenced resource 'test2' not > defined. > > And cat /proc/drbd display only the unstacked test resource > > 3: cs:Connected ro:Primary/Secondary ds:UpToDate/UpToDate C r----- > ns:0 nr:0 dw:0 dr:528 al:0 bm:0 lo:0 pe:0 ua:0 ap:0 ep:1 wo:b oos:0 > > On vm03 and vm04 i can't also find a stacked resource in /proc/drbd > > 3: cs:Connected ro:Primary/Secondary ds:UpToDate/UpToDate C r----- > ns:0 nr:0 dw:0 dr:536 al:0 bm:0 lo:0 pe:0 ua:0 ap:0 ep:1 wo:b oos:0 > > drbdadm dump all > drbd.d/stest.res:1: in resource stest, referenced resource 'test' not > defined. > > You see that on the referenced resource are different between vm01-02 > and vm03-04. On the example the unstacked resources had also different > names. In this part DRBD need to know that the referenced resource test > is also available on vm01-02 and test2 is only available on vm03-04. > That is the problem what i need to solve or not? Yes ... put _all_ resource configs on _all_ nodes (and include them in your config of course): the same config on all four nodes Regards, Andreas -- Need help with DRBD? http://www.hastexo.com/now > > Best regards > Benjamin > >> >> Regards, >> Andreas >> >> >> >> >> _______________________________________________ >> drbd-user mailing list >> drbd-user at lists.linbit.com >> http://lists.linbit.com/mailman/listinfo/drbd-user > > > > > _______________________________________________ > drbd-user mailing list > drbd-user at lists.linbit.com > http://lists.linbit.com/mailman/listinfo/drbd-user -------------- next part -------------- A non-text attachment was scrubbed... Name: signature.asc Type: application/pgp-signature Size: 286 bytes Desc: OpenPGP digital signature URL: <http://lists.linbit.com/pipermail/drbd-user/attachments/20120117/e2cef658/attachment.pgp>