[DRBD-user] Active/Passive iSCSI

Gavin netmatters at gmail.com
Wed Jan 11 11:43:55 CET 2012

Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.


On 11/01/2012, Pedro Henrique Morsch Mazzoni <phmazzoni at gmail.com> wrote:
> Hello everyone,
>
> I am studying the Active/Passive iSCSI configuration on the guide:
>
> http://www.linbit.com/en/education/tech-guides/highly-available-iscsi-with-drbd-and-pacemaker/
>
> The guide says that we have to configure a Virtual IP for the iSCSI target.
> But it doens't detail the network configuration.
>
> 1 - How do I select the network interfaces to use for iSCSI?
>
> 2 - Each server must have a interface on the same subnet of the iSCSI VIP,
> correct? If yes, then how do I point that on crm? How do I tie this things
> togheter?

Hi,

Take a look at the crm cli utility for configuring pacemaker/corosync,
that should be explained in all the DRBD/Pacemaker guides.

You need to configure pacemaker and pacemaker will bring up the iSCSI
targets as well as the virtual IP.

Hope this helps.
Regards,
Gavin



More information about the drbd-user mailing list