Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
Don't use a direct connexion, I have many problems for this in the pass... Is better buy a good switch (netgear has por 35€)... On Fri, Apr 6, 2012 at 9:33 AM, Florian Haas <florian at hastexo.com> wrote: > On Fri, Apr 6, 2012 at 3:10 AM, Brian R. Hellman <brian at linbit.com> wrote: > > > > > > On 04/05/2012 05:58 PM, Marcelo Pereira wrote: > >> Hi DRBD masters, > >> > >> I have been trying to push the sync speed to the limit, as the server > >> was offline for a while and I will release it for general use only > >> after it's sync'ed. So, nobody is using and I can use full speed. > >> > >> I have two servers, each one connected to a NAS unit through a CAT6 > >> cable, no switches in between. It's 1000 Mpbs full duplex, as the > >> ethtool says. > >> > >> I tried to push to the limit, issuing the following: > >> > >> [~]# /sbin/drbdsetup /dev/drbd0 syncer -r 685M > > Please note that this rate is in MB/sec not Mb/s, ideally you should set > > it around 80% of your connection speed. > > Did the 30% recommendation change (for statically defined sync rates), > and if it did, when and why? > http://www.drbd.org/users-guide/s-configure-sync-rate.html does still > mention it. > > Cheers > Florian > > -- > Need help with High Availability? > http://www.hastexo.com/now > _______________________________________________ > drbd-user mailing list > drbd-user at lists.linbit.com > http://lists.linbit.com/mailman/listinfo/drbd-user > -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.linbit.com/pipermail/drbd-user/attachments/20120409/e271bace/attachment.htm>