Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
Hi, We installed heartbeat through yum install which defaults install version 2. Also we tried to install v3 by compiling it but that also doesn't work. Regards, Harshada -----Original Message----- From: Felix Frank [mailto:ff at mpexnet.de] Sent: Friday, May 27, 2011 3:01 PM To: harshada Cc: 'drbd-user'; 'Ashwin Wadhwa' Subject: Re: [DRBD-user] DRBD setup problem On 05/27/2011 11:21 AM, harshada wrote: > Hi, > Yes we tried by restarting heartbeat. > > Kindly note we are using heartbeat 2.1.4. > > Also we are using the same ha.cf file for v2 as mentioned in the document. You are? Strange, I found this in your link: keepalive 2 deadtime 30 warntime 10 initdead 30 crm yes node n1.cl.axilab.local n2.cl.axilab.local bcast eth0 Your's not only uses different options, but also is full of comments (which are presumably from your distributor). Is there a reasong you're not using a "v3" style setup? Regards, Felix