Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
Hi! Am 05/19/2011 03:48 PM, schrieb Digimer: > Setting a sync speed greater than the actual possible speed can hurt > performance. You said that you sustained ~200M before, right? Try > setting the sync rate to 180M and see if that works any better. I set it to 180M like suggested but no improvement unfortunately. The "show" parameter showed the same syncer rate that I set up. Then I switched back to 100M but the speed is still around 5,500 K/sec. Any other config parameters that I could have forgotten? :-/ As I already wrote: The only thing that changed in the setup are the GBICs that I added to one of both switches. Ok, as I obviously haven't been informed by the system about the split-brain occurrence I cannot say how long the issue has been persisting already. :-( CU, Mészi.