[DRBD-user] DRBD won't take 1G syncer rate

Caspar Smit c.smit at truebit.nl
Fri Aug 5 08:29:17 CEST 2011

Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.

Hi Matt,

1000M means 1000 Mb/s NOT 1000mbps. To reach 1000M you should have at least
one (probably two) 10gbit interface(s). Since you have two 1gbit interfaces
(bonded with balance-rr?) a value between 100M and around 170M would be more

Kind regards,
Op 5 aug. 2011 08:21 schreef "Matt Baer" <mbaer at lrnet1.com> het volgende:
> When setting the syncer rate in drbd.conf to 1G, it won't start, citing
> 1G is invalid. Get the same thing with 1000M. Any clue as to why? It
> explicitly states that <mbaer at lrnet1.com>1G is acceptable in the docs.
> triple checked and both interfaces are auto-negotiated at 1000mbps full
> duplex.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.linbit.com/pipermail/drbd-user/attachments/20110805/d0d2ff90/attachment.htm>

More information about the drbd-user mailing list