Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
On Thursday 20 May 2010 20:39:40 Ben Timby wrote: > On Thu, May 20, 2010 at 2:15 PM, Lee Riemer <lriemer at bestline.net> wrote: > > Do you need multiple destination IPs to properly balance? It is my > > understanding that a single stream will only traverse a single link. > > Hence the MPIO requirement. > > Actually, balance-rr is the only mode that can stripe a single packet > stream across multiple interfaces. However, it requires the > cooperation of your switch. > > http://www.linuxfoundation.org/collaborate/workgroups/networking/bonding#Co > nfiguring_Bonding_for_Maximum_Throughput > > "This mode requires the switch to have the appropriate ports > configured for "etherchannel" or "trunking." > _______________________________________________ > drbd-user mailing list > drbd-user at lists.linbit.com > http://lists.linbit.com/mailman/listinfo/drbd-user > Mmm, odd. I read in a couple of posts balance-rr is the best mode for direct connections (as I'm using them, i.e. without switch). I did do some test with a HP Procurve 1810s switch though (enabled trunking on every pair of ports) but this actually resulted in even lower values.