Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
On Wed, Apr 28, 2010 at 05:52:18PM -0400, Chad Sine wrote:
> DRBD Users,
>
> I'm setting up 2 CentOS 5.4 x86_64 servers to use DRBD. I set them up to do
> RAID1, but /dev/drbd0 only shows up at 12GB instead of the 1.8 TB that the
> underlying devices have.
>
> Both boxes are configured just like this, with 1800GB for /dev/sda4
>
> [root at centos54 etc]# parted
> GNU Parted 1.8.1
> Using /dev/sda
> Welcome to GNU Parted! Type 'help' to view a list of commands.
> (parted) print
>
> Model: Dell VIRTUAL DISK (scsi)
> Disk /dev/sda: 2000GB
> Sector size (logical/physical): 512B/512B
> Partition Table: msdos
>
> Number Start End Size Type File system Flags
> 1 32.3kB 206MB 206MB primary ext3 boot
> 2 206MB 108GB 107GB primary ext3
> 3 108GB 120GB 12.8GB primary ext3
^^^ ^^^^^^
> 4 120GB 1920GB 1800GB primary
>
> Here is the /etc/drbd.conf used on each
> disk /dev/sda3;
^^^^
> However, now if I run parted on /dev/drbd0, it is only 12 GB, instead of
^^^^^^^
Hope that helps.
> 1.8TB. I tried doing the following, but I still only get a 12GB partition
>
> # mkfs.ext3 /dev/drbd0
wow.
what was supposed to be on sda3?
whatever it was, it is now gone.
--
: Lars Ellenberg
: LINBIT | Your Way to High Availability
: DRBD/HA support and consulting http://www.linbit.com
DRBD® and LINBIT® are registered trademarks of LINBIT, Austria.
__
please don't Cc me, but send to list -- I'm subscribed