[DRBD-user] how to make a nodo goes standalone mode?

Valentin Vidic Valentin.Vidic at CARNet.hr
Wed Mar 11 22:29:40 CET 2009

Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.


On Wed, Mar 11, 2009 at 02:11:57PM +0100, matteo filippetto wrote:
>  5: cs:WFConnection st:Primary/Unknown ds:UpToDate/DUnknown C r---
>     ns:1735972 nr:0 dw:2044512 dr:48177 al:96 bm:43 lo:0 pe:0 ua:0 ap:0
>         resync: used:0/31 hits:0 misses:0 starving:0 dirty:0 changed:0
>         act_log: used:0/257 hits:444933 misses:96 starving:0 dirty:0 changed:96
>  6: cs:WFConnection st:Primary/Unknown ds:UpToDate/DUnknown C r---
>     ns:0 nr:0 dw:0 dr:272 al:0 bm:0 lo:0 pe:0 ua:0 ap:0
>         resync: used:0/31 hits:0 misses:0 starving:0 dirty:0 changed:0
>         act_log: used:0/257 hits:0 misses:0 starving:0 dirty:0 changed:0
> 
> where device 4 is data and device 5 and 6 is disks of a xen virtual machine.
> 
> I need to set cs:StandAlone also for device 5 and 6.

I'm not sure what you're trying to do here, but 'drbdadm disconnect drbd5'
should bring drbd5 in cs:StandAlone. Same goes for drbd6.

-- 
Valentin



More information about the drbd-user mailing list