Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
On Wed, Sep 17, 2008 at 03:53:39PM -0400, Edward Capriolo wrote: > I have a Cent OS 5 x86_64, and have installed LinuxVServer kernel > 2.6.22.19-vs2.3.0.34.1, I am looking to install DRBD on a two node > setup. I have followed the install guide for building DRBD as a kernel > module as well as the userland tools. > Everything works fine up until the point I try 'The initial device > synchronization' > > drbdadm -c /opt/jtg/conf/www2/drbd/www2-drbd.conf -- > --overwrite-data-of-peer primary www2 > > At which point the primary device loses contact with the secondary device > > drbd0: 416 MB (106483 bits) marked out-of-sync by on disk bit-map. > Writing meta data super block now. > conn( Connected -> WFBitMapT ) > conn( WFBitMapT -> WFSyncUUID ) > helper command: /sbin/drbdadm before-resync-target > before-resync-target handler returned 10, dropping connection. _please_ make sure that your userland is at least the same version as your kernel module. > peer( Primary -> Unknown ) conn( WFSyncUUID -> Disconnecting ) pdsk( > UpToDate -> DUnknown ) > asender terminated > > One node looks like: > 0: cs:WFConnection st:Primary/Unknown ds:UpToDate/Inconsistent C r- > cs:StandAlone st:Secondary/Unknown ds:Inconsistent/DUnknown -- : Lars Ellenberg : LINBIT | Your Way to High Availability : DRBD/HA support and consulting http://www.linbit.com DRBD® and LINBIT® are registered trademarks of LINBIT, Austria. __ please don't Cc me, but send to list -- I'm subscribed