[DRBD-user] Serious problems with perfomance drdb

Robert reg at elconas.de
Wed Oct 1 10:44:16 CEST 2008

Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.


Hi Petr,

ethtool eth1 output ?

is eth1 1000 Mbit Full Duplex ?
What's the latency over eth1 ?

Regards,
Robert

>
> #  /etc/ietd.conf
> Target iqn.2008-09.com:storage.r0
>         IncomingUser iscsi XXXXXXXXXXXX
>         Lun 0 Path=/dev/drbd0,Type=fileio
>
> # ifconfig eth1
> eth1      Link encap:Ethernet  HWaddr 00:30:48:d2:1b:37
>           inet addr:10.133.133.1 <http://10.133.133.1>  
> Bcast:10.133.133.3 <http://10.133.133.3>  Mask:255.255.255.252 
> <http://255.255.255.252>
>           inet6 addr: fe80::230:48ff:fed2:1b37/64 Scope:Link
>           UP BROADCAST RUNNING MULTICAST  MTU:9000  Metric:1
>           RX packets:31057691 errors:0 dropped:0 overruns:0 frame:0
>           TX packets:66325409 errors:0 dropped:0 overruns:0 carrier:0
>           collisions:0 txqueuelen:1000
>           RX bytes:3125652368 (2.9 GB)  TX bytes:2951365778 (2.7 GB)
>           Base address:0x3000 Memory:d8400000-d8420000
>
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> drbd-user mailing list
> drbd-user at lists.linbit.com
> http://lists.linbit.com/mailman/listinfo/drbd-user
>   




More information about the drbd-user mailing list