[DRBD-user] drbd8 - multiple routes between nodes

Grégory Steulet Gregory.Steulet at trivadis.com
Wed Mar 19 13:28:49 CET 2008

Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.


Hello Guy,

I was also looking for such a possibility. Unfortunatelty for the moment the only way to do that is bonding your eth devices. I'm testing this configuration on VmWare with an SLES10, for the moment it looks good.

Greg 




-----Original Message-----
From: drbd-user-bounces at lists.linbit.com on behalf of Guy
Sent: Wed 3/19/2008 11:28 AM
To: drbd-user at lists.linbit.com
Subject: [DRBD-user] drbd8 - multiple routes between nodes
 
Hi,

I've just started using drbd8 with heartbeat v2 + CRM with the hopes
of using it in a production environment relatively soon. Testing so
far has been great, but is it possible to use more than one address
for a device?

Something like:
  on drbd1 {
    device     /dev/stor1;
    disk       /dev/hdc4;
    address    10.0.0.11:7788;
    address    217.13.49.111:7788;
    meta-disk  /dev/hdc2[0];
  }

  on drbd2 {
    device     /dev/stor1;
    disk       /dev/hdc4;
    address    10.0.0.12:7788;
    address    217.13.49.112:7788;
    meta-disk  /dev/hdc2[0];
  }

Or perhaps have failover ips as the machines will two interfaces set
up on different networks? If drbd can use both networks it would
provide an extra level of redundancy to the connectivity between the
nodes.

Thanks
Guy

-- 
Don't just do something...sit there!
_______________________________________________
drbd-user mailing list
drbd-user at lists.linbit.com
http://lists.linbit.com/mailman/listinfo/drbd-user




More information about the drbd-user mailing list