Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
On Tuesday 18 March 2008 21:12:43 Ítalo Rossi wrote: > Hello all, > > We have two nodes with drbd8.2.5 installed (redhat AS - kernel > 2.6.23.12 and debian etch - kernel 2.6.22). > > My primary node (debian etch) needed to be halted for some time, so I > put the secondary node on primary state and run my services without > any problem. > > When the other (debian etch) node become active, the resync cause a > high load average on the redhat node (~= 130). > > Suspecting of low I/O's capacity and my application having hard write > on disk, I've tried to reduce the transfer rate from 100M to 30M but: > > # drbdadm adjust -d resource > 7018381312s: out of range Well, it doesn't help much to state that you had a problem that surfaced when issuing "drbdadm adjust", and _not_ including your drbd.conf... Please provide that. Thank you. Cheers, Florian -- : Florian G. Haas : LINBIT Information Technologies GmbH : Vivenotgasse 48, A-1120 Vienna, Austria When replying, there is no need to CC my personal address. I monitor the list on a daily basis. Thank you.