[DRBD-user] Speed Sync seems to be limited on gigabit ethernet

Mike Tewner tewner at gmail.com
Wed Jun 20 15:58:43 CEST 2007

Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.


in drbd.conf
common { syncer { rate 100M; } }

Make sure that the hostnames in the drbd.conf resolve to the IP of the
interface with the crossover

On 6/20/07, Marcello Lupo <mlist at itspecialist.it> wrote:
>
> Hi to all,
> i'm making a new installation on SLES 10 x86_64 on 2 HP Proliant DL380
> multiprocessor servers with 2 Ultra 320 SCSI disks of 146 Gb in raid1 on
> each using Smart Array 6i hardware raid controller. Both servers have
> 2GB ram.
> The 2 servers are connected on public network on eth0 and connected with
> cross cable on eth1 dedicated for sync of drbd, both Gigabit ethernet.
> When i make scp of one big file from one server to the other i reach
> 50Mb/sec speed. If i force the sync of the partitions to drbd with
> invalidate_remote it do not go over 12 Mb/sec.
>
> version: 0.7.21 (api:79/proto:74)
> SVN Revision: 2341 build by lmb at dale, 2006-08-10 14:19:54
>   0: cs:SyncSource st:Primary/Secondary ld:Consistent
>      ns:41370104 nr:0 dw:0 dr:41371732 al:0 bm:6109 lo:0 pe:201 ua:407
> ap:0
>          [==============>.....] sync'ed: 70.5% (16949/57349)M
>          finish: 0:22:15 speed: 12,968 (12,672) K/sec
>
> It seems like it is limited to network connection of 10Mbit.
> i tried with rate option to 50M,40M,30M and it is the same.
> I'm using protocol C.
>
> Partitions are as follows:
>
>        Device Boot      Start         End      Blocks   Id  System
> /dev/cciss/c0d0p1   *           1          13      104391   83  Linux
> /dev/cciss/c0d0p2              14         536     4200997+  82  Linux
> swap / Solaris
> /dev/cciss/c0d0p3             537        3147    20972857+  83  Linux
> /dev/cciss/c0d0p4            3148       17848   118085782+   f  W95
> Ext'd (LBA)
> /dev/cciss/c0d0p5            3148       10458    58725576   83  Linux
> /dev/cciss/c0d0p6           10459       17769    58725576   83  Linux
> /dev/cciss/c0d0p7           17770       17848      634536   83  Linux
>
> Partitions for the system are p1/p2/p3, partitions to be synced are p5
> and p6 (now testing only with p5), i'm using the last partition p7 as
> metadisk partition.
>
> DRBD version 0.7.21 and kernel 2.6.16.27-0.9-smp x86_64
>
> If you have any clue on the possible cause please let me know. May be
> this speed is normal for this kind of environment or may be i have to
> tune some network parameters.
> Thanks,
> Bye,
> Marcello
>
> _______________________________________________
> drbd-user mailing list
> drbd-user at lists.linbit.com
> http://lists.linbit.com/mailman/listinfo/drbd-user
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.linbit.com/pipermail/drbd-user/attachments/20070620/1e9f9462/attachment.htm>


More information about the drbd-user mailing list