Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
Hi,
i am running drbd with heartbeat - actually it worked fine for like 30
days. Yesterday suddenly following error happend:
attempt to access beyond end of device
drbd1: rw=0, want=9699344, limit=9505312
EXT3-fs error (device drbd1): read_inode_bitmap: Cannot read inode bitmap
- block_group = 37, inode_bitmap = 1212417
Aborting journal on device drbd1.
EXT3-fs error (device drbd1) in ext3_new_inode: IO failure
EXT3-fs error (device drbd1) in ext3_create: IO failure
ext3_abort called.
EXT3-fs error (device drbd1): ext3_journal_start_sb: Detected aborted
journal
Remounting filesystem read-only
Problem is, that my Partition is now read only. I allready used to stop
drbd / umount the devices and remounted it again. After 1-2 hours I had
the same Problem again. When I used to mount the device, following error
showed up:
EXT3-fs warning (device drbd2): ext3_clear_journal_err: Filesystem error
recorded from previous mount: IO failure
EXT3-fs warning (device drbd2): ext3_clear_journal_err: Marking fs in need
of filesystem check.
EXT3-fs warning: mounting fs with errors, running e2fsck is recommended
EXT3 FS on drbd2, internal journal
EXT3-fs: recovery complete.
EXT3-fs: mounted filesystem with ordered data mode.
What might be wrong? I mean it worked before without any problems ?
cat /proc/drbd
----------------------
version: 0.7.21 (api:79/proto:74)
SVN Revision: 2326 build by root at nt3000-slave, 2007-04-23 15:37:50
0: cs:Connected st:Primary/Secondary ld:Consistent
ns:1822716 nr:119012 dw:1941728 dr:24833 al:4 bm:12 lo:0 pe:0 ua:0
ap:0
1: cs:Connected st:Primary/Secondary ld:Consistent
ns:3764052 nr:236124 dw:4006376 dr:53970 al:269 bm:30 lo:0 pe:0 ua:0
ap:0
2: cs:Connected st:Primary/Secondary ld:Consistent
ns:5539816 nr:724 dw:5540540 dr:83139 al:191 bm:3 lo:0 pe:0 ua:0 ap:0
df output:
-------------
/dev/drbd0 1921188 66768 1756828 4% /etc/asterisk
/dev/drbd1 4806904 378400 4184320 9%
/var/spool/asterisk
/dev/drbd2 3842376 345356 3301832 10% /var/log/asterisk
fdisk output:
------------------
drbd0 = sda3
Disk /dev/sda3: 1998 MB, 1998743040 bytes
255 heads, 63 sectors/track, 243 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Disk /dev/sda3 doesn't contain a valid partition table
drbd1 = sda5
Disk /dev/sda5: 5000 MB, 5000937984 bytes
255 heads, 63 sectors/track, 607 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Disk /dev/sda5 doesn't contain a valid partition table
drbd2 = sda6
Disk /dev/sda6: 3997 MB, 3997453824 bytes
255 heads, 63 sectors/track, 485 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Disk /dev/sda6 doesn't contain a valid partition table
Thanks advance!
Bastian Marmetschke