Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
Hi Dave, Just a short guess: On node2 you have in drbd.conf /dev/sedb1 as the physical device, is that correct ? Nico Dave Buechler schreef: > Hi all, > > Using a stock CentOS 5.0 install, I have been attempting to establish > replication of a large LVM2 partition (approximately 1TB). > Unfortunately, after creating drbd0 and completing the initial sync, the > primary node will kernel panic referencing drbd_req.c, line 374 -- I > think. Forgive me, I don't have the panic message in front of me. > > My configuration is as follows: > > a partition on sdb1 on both nodes, with a type 8e (LVM) > create metadata on /dev/drbd0 > make a node primary with -o flag > finish syncing (or not - it doesn't appear to make any difference) > create physical volume on /dev/drbd0 -- kernel will panic. > > Can anyone tell me what I may be doing wrong? I've been researching the > problem without much luck. Any insight would be very helpful. > > Thanks for your time. > > I'm attaching copies of my config files below. > -- Behandeld door / Handled by: N.J. van der Horn (Nico) --- ICT Support Vanderhorn IT-works, www.vanderhorn.nl, Voorstraat 55, 3135 HW Vlaardingen, The Netherlands, Tel +31 10 2486060, Fax +31 10 2486061