Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
> ----- Original Message -----
> From: Jason Joines <support-lmNaKLgJNgdcusGGlJDZ6w at public.gmane.org>
> Sent: 10/08/2006 05:19:02 PM
> Subject: onine resizing
>
> I'm using SuSE 9.2 with kernel 2.6.10 and drbd "version: 0.7.10
> (api:77/proto:74)" on a two node setup serving Samba and about to run
> out of disk space on my second drbd device drbd1. Samba and DRBD are
> controlled via Heartbeat 1.2.3. XFS is the filesytem.
>
> Short question is how do I use the resize feature of
> drbdadm/drbdsetup? What I've done so far follows.
>
> The disks in each node are exactly the same, each had one remaining
> drive slot, I had two extra drives identical to those already in use.
>
> I took nodeB down, added the drive, configured it and the existing
> drive as md0 with raid0, verified md0 was twice the size of the
> individual disks, modified drbd.conf on each node to show /dev/md0 as
> the disk behind the drbd device instead of /dev/sdc.
> Then I brought DRBD up on nodeB in StandAlone mode, invalidated the
> drbd on nodeB, connected and allowed the Sync from nodeA to nodeB to run
> to completion. Next I failed Samba over to nodeB via Heartbeat's
> hb_standby and verified everything was working OK, Samba and shares
> accessible, data on drbd device OK, etc.
> At this point, df output still looks like it did with just one disk
> behind the drbd device as I expected:
> /dev/drbd1 xfs 137G 134G 3.3G 98% /local/groups
>
> I then repeated on nodeA, took it down, added the drive, configured
> md0 out of sdc and sda, modified drbd.conf to use md0, invalidated
> locally on nodeA, connected the drbd device and allowed the Sync to run
> from nodeB back to nodeA. I then failed everything back over to nodeA
> and again made sure all was working correctly. It was and the disk
> usage/size was still as above.
>
> Then I issued "drbdadm resize drbd1" on nodeA and on nodeB. Didn't
> see any difference in disk size/usage and thought it might require a
> umount of the filesystem so I failed everything back over to nodeB.
> There was still no difference in disk size/usage so I repeated with
> still no luck.
>
> Issuing the "drbdadm resize drbd1" command results in these log
> messages on the local node when Secondary:
> Oct 8 17:03:19 nodeA kernel: drbd1: I am(S):
> 1:00000003:00000002:000000aa:00000009:01
> Oct 8 17:03:19 nodeA kernel: drbd1: Peer(P):
> 1:00000003:00000002:000000aa:00000009:11
> Oct 8 17:03:19 nodeA kernel: drbd1: drbd1_receiver [7873]: cstate
> Connected --> WFBitMapT
> Oct 8 17:03:20 nodeA kernel: drbd1: drbd1_receiver [7873]: cstate
> WFBitMapT --> SyncTarget
> Oct 8 17:03:20 nodeA kernel: drbd1: Resync started as SyncTarget (need
> to sync 0 KB [0 bits set]).
> Oct 8 17:03:20 nodeA kernel: drbd1: Resync done (total 1 sec; paused 0
> sec; 0 K/sec)
> Oct 8 17:03:20 nodeA kernel: drbd1: drbd1_receiver [7873]: cstate
> SyncTarget --> Connected
>
> and these on the local node when Primary:
> Oct 8 17:06:44 nodeB kernel: drbd1: I am(P):
> 1:00000003:00000002:000000aa:00000009:11
> Oct 8 17:06:44 nodeB kernel: drbd1: Peer(S):
> 1:00000003:00000002:000000aa:00000009:01
> Oct 8 17:06:44 nodeB kernel: drbd1: drbd1_receiver [16338]: cstate
> Connected --> WFBitMapS
> Oct 8 17:06:44 nodeB kernel: drbd1: drbd1_receiver [16338]: cstate
> WFBitMapS --> SyncSource
> Oct 8 17:06:44 nodeB kernel: drbd1: Resync started as SyncSource (need
> to sync 0 KB [0 bits set]).
> Oct 8 17:06:44 nodeB kernel: drbd1: Resync done (total 1 sec; paused 0
> sec; 0 K/sec)
> Oct 8 17:06:44 nodeB kernel: drbd1: drbd1_receiver [16338]: cstate
> SyncSource --> Connected
>
> No corresponding messages are generated on the other node.
>
> Now I have a 268 GB md device being used behind drbd1 on each node
> but still only have 134 GB available for use. Any ideas?
>
>
> Thanks,
>
> Jason Joines
> ================================
Found and remedied one problem but still don't have the devices
resized. Issuing the "drbdadm resize drbd1" command wasn't generating
corresponding commands on the other node as their system time had got
out of sync by about 3 minutes when taking them down to add the drive as
the time server I was syncing to has been down.
After getting the system times on each node back in sync
corresponding entries are generated. With nodeB running as primary I
issued the command on it and then a few seconds later ( 47s later
apparently ) issued it on nodeA which was running as secondary:
Oct 8 17:14:10 nodeB kernel: drbd1: I am(P):
1:00000003:00000002:000000aa:00000009:11
Oct 8 17:14:10 nodeB kernel: drbd1: Peer(S):
1:00000003:00000002:000000aa:00000009:01
Oct 8 17:14:10 nodeB kernel: drbd1: drbd1_receiver [16338]: cstate
Connected --> WFBitMapS
Oct 8 17:14:11 nodeB kernel: drbd1: drbd1_receiver [16338]: cstate
WFBitMapS --> SyncSource
Oct 8 17:14:11 nodeB kernel: drbd1: Resync started as SyncSource (need
to sync 0 KB [0 bits set]).
Oct 8 17:14:11 nodeB kernel: drbd1: Resync done (total 1 sec; paused 0
sec; 0 K/sec)
Oct 8 17:14:11 nodeB kernel: drbd1: drbd1_receiver [16338]: cstate
SyncSource --> Connected
Oct 8 17:14:58 nodeB kernel: drbd1: I am(P):
1:00000003:00000002:000000aa:00000009:11
Oct 8 17:14:58 nodeB kernel: drbd1: Peer(S):
1:00000003:00000002:000000aa:00000009:01
Oct 8 17:14:58 nodeB kernel: drbd1: drbd1_receiver [16338]: cstate
Connected --> WFBitMapS
Oct 8 17:14:58 nodeB kernel: drbd1: drbd1_receiver [16338]: cstate
WFBitMapS --> SyncSource
Oct 8 17:14:58 nodeB kernel: drbd1: Resync started as SyncSource (need
to sync 0 KB [0 bits set]).
Oct 8 17:14:58 nodeB kernel: drbd1: Resync done (total 1 sec; paused 0
sec; 0 K/sec)
Oct 8 17:14:58 nodeB kernel: drbd1: drbd1_receiver [16338]: cstate
SyncSource --> Connected
Oct 8 17:14:10 nodeA kernel: drbd1: I am(S):
1:00000003:00000002:000000aa:00000009:01
Oct 8 17:14:10 nodeA kernel: drbd1: Peer(P):
1:00000003:00000002:000000aa:00000009:11
Oct 8 17:14:10 nodeA kernel: drbd1: drbd1_receiver [7873]: cstate
Connected --> WFBitMapT
Oct 8 17:14:11 nodeA kernel: drbd1: drbd1_receiver [7873]: cstate
WFBitMapT --> SyncTarget
Oct 8 17:14:11 nodeA kernel: drbd1: Resync started as SyncTarget (need
to sync 0 KB [0 bits set]).
Oct 8 17:14:11 nodeA kernel: drbd1: Resync done (total 1 sec; paused 0
sec; 0 K/sec)
Oct 8 17:14:11 nodeA kernel: drbd1: drbd1_receiver [7873]: cstate
SyncTarget --> Connected
Oct 8 17:14:58 nodeA kernel: drbd1: I am(S):
1:00000003:00000002:000000aa:00000009:01
Oct 8 17:14:58 nodeA kernel: drbd1: Peer(P):
1:00000003:00000002:000000aa:00000009:11
Oct 8 17:14:58 nodeA kernel: drbd1: drbd1_receiver [7873]: cstate
Connected --> WFBitMapT
Oct 8 17:14:58 nodeA kernel: drbd1: drbd1_receiver [7873]: cstate
WFBitMapT --> SyncTarget
Oct 8 17:14:58 nodeA kernel: drbd1: Resync started as SyncTarget (need
to sync 0 KB [0 bits set]).
Oct 8 17:14:58 nodeA kernel: drbd1: Resync done (total 1 sec; paused 0
sec; 0 K/sec)
Oct 8 17:14:58 nodeA kernel: drbd1: drbd1_receiver [7873]: cstate
SyncTarget --> Connected
Jason
===========