Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
Thanks, I'll remember that. I downgraded to the .7 series and it seems to working fine now. -Martin --- Diego Julian Remolina <diego.remolina at ibb.gatech.edu> wrote: > Not sure if you already went through this, but it > may help you find out where the problem is. > > drbdadm -d adjust RESOURCE_NAME > > This will show you what is needed to actually get > drbd ready to work according to your drbd.conf. > > [root at sauron /]# drbdadm -d adjust export > /sbin/drbdsetup /dev/drbd0 disk /dev/sdb1 /dev/sdb3 > 0 --on-io-error=detach > /sbin/drbdsetup /dev/drbd0 syncer --rate=60M > --group=1 --al-extents=257 > /sbin/drbdsetup /dev/drbd0 net 10.0.0.21:7789 > 10.0.0.22:7789 C > > From the sample above you can then try running each > one of the commands by hand to try to figure > out which is failing. > > /sbin/drbdsetup /dev/drbd0 disk /dev/sdb1 /dev/sdb3 > 0 --on-io-error=detach > /sbin/drbdsetup /dev/drbd0 syncer --rate=60M > --group=1 --al-extents=257 > /sbin/drbdsetup /dev/drbd0 net 10.0.0.21:7789 > 10.0.0.22:7789 C > > HTH, > > Diego > > Martin Fick wrote: > > I am attempting to setup drbd on debian unstable, > it > > reports version .8pre2. Since I cannot get it to > > work, I am attempting to break things down into > > smaller pieces. To do this, I am attempting to > use > > dbbd setup. If I understand things properly, drbd > > setup is the low level user interface and it > should > > not ever look at drbd.conf right? > > > > When I run it to attpemt to setup a device it > > complains about the meta-data area needing to be > > intialized (or something like that, I'm sorry I'm > at > > work and don't have access to the box right now > for > > the exact error message). The kicker is that the > > error message tells me to run drbdadm create-md > res > > (that was drbdadm,not drbdsetup!). Now this seems > > strange to me since it seems like drbadm runs off > of > > drbd.conf. Is there a way to do this 'create-md' > step > > manually on a device without having to reference > the > > drbd.conf file? > > > > > > This 'drbdadm create-md res' command isn't > documented > > on this page: > > > http://www.drbd.org/fileadmin/drbd/doc/0.7.0/en/drbdadm.html > > What is the 'res' part supposed to be? > > > > -Martin > > > > > > __________________________________________________ > > Do You Yahoo!? > > Tired of spam? Yahoo! Mail has the best spam > protection around > > http://mail.yahoo.com > > _______________________________________________ > > drbd-user mailing list > > drbd-user at lists.linbit.com > > http://lists.linbit.com/mailman/listinfo/drbd-user > __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around http://mail.yahoo.com