Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
I do'nt know why, but the Secondary try to become Primary, and then, the Primary goes in the state StandAlone. Now, how to do to have Primary/Secondary Connected ld: Consistent ????? I stopped drbd on the Secondary The Primary is still: cs:StandAlone st:Primary/Unknown ld:Consistent On the Primary, I do the command drbdadm connect all The Primary is now: WFConnection st:Primary/Unknown ld:Consistent If, now, I restart the Secondary The Primary becomes StandAlone In /var/spool/message Handshake successful: DRBD Network Protocol version 74 Connection established. I am(P): 1:00000003:0000005f:00001370:00000005:10 Peer(S): 1:00000003:00000060:00001367:00000005:00 Current Primary shall become sync TARGET! Aborting to prevent data corruption. On the Secondary, I tried the command drbdadm invalidate r0 But this command failed ioctl(,INVALIDATE,) failed: Operation now in progress Only in 'Connected' cstate possible. Command 'drbdsetup /dev/drbd0 invalidate' terminated with exit code 20 drbdadm aborting Could somebody help me. How to do to reconnect the too computers ? -- ================================================================== | Régis Gras | http://www-ledss.ujf-grenoble.fr | | L.E.D.S.S. | mailto:Regis.Gras at ujf-grenoble.fr | | 301, rue de la chimie | -------------- | | DU BP 53 | Tel 04 76 51 41 76 | | 38041 Grenoble Cedex 9 | Fax 04 76 51 40 89 | ==================================================================