Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
On Mon, 2006-06-19 at 10:39 +0100, Sudhakar Mekathotti wrote: > Hi, > > I'm getting the following error while trying to do a Primary/Primary > config using drbd8.0pre3 and ocfs2. > > $ drbdsetup /dev/drbd0 primary > ioctl(,SET_STATE,) failed: Input/output error > TOO_LARGE > > I've the following setup: > node1: /dev/hda1 11G ocfs2 > /dev/hda2 8G ocfs2 > node2: /dev/hda1 11G ocfs2 > /dev/hda2 8G ocfs2 > > On node1, I made both file systems primary by doing 'drbdadm primary > all'. Everything is working fine in Primary/Secondary mode. But I > would like to mount the filesystems on node2 as well. I think for that you have to make #drbdadm seconday all on node1 and then try doing #drbdadm primary all on node2, and try mounting it. By any reason if its not getting done. You can force it to do that. #drbdadm -- --do-what-I-say primary all see this http://www.drbd.org/drbd-howto.html > So when I try to > make a filesystem primary on node2, I'm getting the error mentioned > above. Any help is greatly appreciated. > > cheers > suds. > _______________________________________________ > drbd-user mailing list > drbd-user at lists.linbit.com > http://lists.linbit.com/mailman/listinfo/drbd-user > > -- ...Milind KGDB-PRO http://www.linsyssoft.com/Kgdbpro.html