Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
Hello Chris,
Yes you need to go back just one revision 1.6.14_1653_FC4.
Best regards.
Francis
Chip Burke wrote:
>Good call. It is FC4 2.6.14_1656 . Do I need to go back just one revision?
>Or is there a specific kernel where this problem popped up?
>
>Thanks so much
>
>________________________________________
>Chip Burke
>
>
>-----Original Message-----
>From: Anquijix Schiptara [mailto:anquijix at hotmail.com]
>Sent: Friday, January 20, 2006 10:34 AM
>To: cburke at innova-partners.com
>Subject: RE: [DRBD-user] mkfs hangs
>
>If you run FC4 with newest kernel, install an older version, reinstall drbd
>module, and all good... There is already a similar thread according to the
>newest FC4-Kernel.
>
>
>
>>From: "Chip Burke" <cburke at innova-partners.com>
>>Reply-To: cburke at innova-partners.com
>>To: <drbd-user at linbit.com>
>>Subject: [DRBD-user] mkfs hangs
>>Date: Fri, 20 Jan 2006 10:13:44 -0500
>>
>>I am running 0.7.15 and I cannot seem to format a drive. When I go to run
>>'mkfs -j /dev/drbd0', mfks hangs while writing the inode tables at the same
>>place every time. If I stop drbd and format the underlying device, it works
>>fine, but the drbd device is not a happy camper. Any ideas as to what the
>>issue may be? /dev/drbd0 is set to primary and syncs just fine with it's
>>slave, so everything seems okay. but the drive isn't much good with out a
>>files system.
>>
>>
>>
>>Thanks!
>>
>>
>>
>>________________________________________
>>Chip Burke
>>
>>
>>
>>
>>
>
>
>
>
>>_______________________________________________
>>drbd-user mailing list
>>drbd-user at lists.linbit.com
>>http://lists.linbit.com/mailman/listinfo/drbd-user
>>
>>
>
>
>
>
>_______________________________________________
>drbd-user mailing list
>drbd-user at lists.linbit.com
>http://lists.linbit.com/mailman/listinfo/drbd-user
>
>
>