[DRBD-user] Lost whole disk data while sync

Longming Lee longming.lee at gmail.com
Sun Sep 11 09:52:29 CEST 2005

Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.


I have installed DRBD-0.7.12 on AS3, ha1 & ha2.
ha1 is the primary and there are many files in it.
ha2 is the secondary, it will be replicated after I start up DRBD.

I have checked that ha1 is primary and ha2 is secondary before I
connected the cross link cable between them. All files in ha1 are
gone after I connected this cable. I don't know what is going on.
This isn't the first time I installed DRBD. I have done before and
they were OK then.

Which commands I can use to force data sync from ha1 to ha2 while these
two ha1 & ha2 are connected firstly, and that can prevent me from
this mistake?



More information about the drbd-user mailing list