Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
Hello, I'm using DRBD 0.7.6 in a configuration where each of the two hosts have eth0/eth1 on the same subnet. For example: server1 server2 eth0: 192.168.0.60 eth0:192.168.0.70 eth1: 192.168.0.61 eth1:192.168.0.71 Now when I establish a DRBD device using the "eth1" addressses (as confirmed with the "show" output): # drbdsetup /dev/drbd0 show Lower device: 58:00 (/dev/vg01/lv01) Meta device: 58:01 (/dev/vg01/lv01_meta) Meta index: 0 Disk options: Local address: 192.168.0.61:9901 Remote address: 192.168.0.71:9901 Wire protocol: C Net options: timeout = 6.0 sec (default) connect-int = 10 sec (default) ping-int = 10 sec (default) max-epoch-size = 2048 (default) max-buffers = 2048 (default) sndbuf-size = 131070 (default) ko-count = 0 (default) Syncer options: rate = 5000 KB/sec group = 0 (default) al-extents = 127 (default) The IP addresses in the above output look correct - however the device starts getting used the "eth0" addresses appear to take the traffic. The "netstat" output confirms this; # netstat -an|grep 9901 tcp 0 0 192.168.0.61:9901 192.168.0.70:33174 ESTABLISHED tcp 0 0 192.168.0.60:33093 192.168.0.71:9901 ESTABLISHED Anyone else come across this or a similar problem? Regards, Simon.