[DRBD-user] Force drbd to specific ethernet port

Brad Barnett lists at l8r.net
Thu Dec 29 18:15:32 CET 2005

Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.


On Wed, 28 Dec 2005 16:48:24 +0000
Luciano Miguel Ferreira Rocha <strange at nsk.no-ip.org> wrote:

> On Wed, Dec 28, 2005 at 05:40:52PM +0100, Andrés Cañada wrote:
> > Hi!
> > I'd like to know if its possible to force drbd to sync data through a
> > specific  ethernet port.
> > I have two directors (master and backup) and they're linked by a
> > crossover  cable over a Gigabit net. I'd like to make sure that the
> > sync process is  doing through this eth ports.
> > Could anyone help me?
> > Thanks in advance.
> > Andrés.
> 
> Do the Gigabit cards have IP addresses on the same net as the other
> ones? In that case, set routes to each other via the gigabit cards.
> 
> Otherwise, just use those IPs in drbd configuration.
> 
> > **NOTA DE CONFIDENCIALIDAD**
> (This is rather pointless in a mailing list, isn't it?)
> 

It is rather pointless and inane anywhere.  You are granted rights, not by
professing that you have them, but by law.

Sputtering on about what rights you have, does not aid you in any way...

Blathering on about rights you do not have, does not grant you them.



More information about the drbd-user mailing list