[DRBD-user] Force drbd to specific ethernet port

Luciano Miguel Ferreira Rocha strange at nsk.no-ip.org
Wed Dec 28 17:48:24 CET 2005

Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.


On Wed, Dec 28, 2005 at 05:40:52PM +0100, Andrés Cañada wrote:
> Hi!
> I'd like to know if its possible to force drbd to sync data through a specific 
> ethernet port.
> I have two directors (master and backup) and they're linked by a crossover 
> cable over a Gigabit net. I'd like to make sure that the sync process is 
> doing through this eth ports.
> Could anyone help me?
> Thanks in advance.
> Andrés.

Do the Gigabit cards have IP addresses on the same net as the other ones?
In that case, set routes to each other via the gigabit cards.

Otherwise, just use those IPs in drbd configuration.

> **NOTA DE CONFIDENCIALIDAD**
(This is rather pointless in a mailing list, isn't it?)

-- 
lfr
0/0



More information about the drbd-user mailing list