Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
I have a two node DRBD system. When I bring down the Secondary node, the
Primary node goes into the WFConnection state which is just fine. When I
bring up the Secondary node again, I do a
drbdadm attach drbd0
drbdadm resize drbd0
drbdadm syncer drbd0
drbdadm connect drbd0
manually. When I do the "drbdadm connect drbd0" command on the
Secondary, the Primary immediately goes into the "Standalone" state! Why
is this? This is very odd. Thank you.
Scott Simpson
ssimpson at visionsolutions.com
Scott Simpson
Advisory Software Engineer
Vision Solutions, inc.
17911 Von Karman Ave, 5th Floor
Irvine, CA 92614
UNITED STATES
Tel: +1 (949) 660-7463
Fax: +1 (949)225-0287
Email: ssimpson at visionsolutions.com
<http://www.visionsolutions.com/>
Disclaimer - 12/7/2005
The contents of this e-mail (and any attachments) are confidential, may be privileged, and may contain copyright material of Vision Solutions, Inc. or third parties. You may only reproduce or distribute the material if you are expressly authorized by Vision Solutions to do so. If you are not the intended recipient, any use, disclosure or copying of this e-mail (and any attachments) is unauthorized. If you have received this e-mail in error, please immediately delete it and any copies of it from your system and notify us via e-mail at helpdesk at visionsolutions.com