Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
Hi, even removing that line it still freeze..
ps: it doesn't freeze after 60 seconds of sync, it freezes when sync reachs
exactly 47%
thanks
> Try removing the
>
> incon-degr-cmd "echo '!DRBD! pri on incon-degr' | wall ; sleep 60
>
> from the drbd.conf. Get a full sync then add the above line. If you
> are doing a first sync for the first time the above line can cause
> problems.
>
> Cheers
>
> Tim Hibbard
>
> Flavio Caetano wrote:
> >Hi,
> >
> >I'm sending again the same email because I don't get answer.
> >Talking with the kernel peoples in kernelnewbies they suggest me enable
> > some options for kernel debug, but none of them show me any info before
> > freeze...
> >
> >"talk with drbd peoples!" they said, so I'm trying again! hehe
> >
> >I need some kind of advice to know who is freezing my machine, if is
> > really drbd module or something else
> >
> >Thanks
> >
> >Flávio
> >
> >>Hi
> >>
> >>I have two machines running debian 3.1 + kernel 2.6.12.4
> >>
> >>I have setup DRBD on three resources. franciele-radius, franciele-named
> >> and franciele-mysql. When I start DRBD on both machines and tell what is
> >> the primary the sync begins.
> >>
> >>The two first resources sync'ed ok, but another resource freezes my
> >>SyncTarget machine when it reaches 47% of sync'ed it full freeze, no
> >> logs, no keyboard. Defining "DBG_ALL_SYMBOLS" in drbd_config.h doesn't
> >> help, enabling nmi_watchdog on my processor doesn't generate an oops,
> >> magic sysrq doesn't work, memtest shows that my memory is ok, the
> >> machine just DIED.
> >>
> >>After a hard reboot if I clean my meta-disk disk the sync begin again and
> >>machine freezes on 47%, if I dont clean meta-disk the machine freezes at
> >>the same time that I type: /etc/init.d/drbd start.
> >>
> >>SyncSource machine have a SMP processor and two SATA disks
> >>SyncTarget machine have an UP processor and two IDE disks (with no
> >>badblocks of course)
> >>Both machines have DRBD 0.7.11
> >>
> >>
> >>I'll paste the drbd.conf below
> >>
> >>====================
> >>resource franciele-radius {
> >> protocol B;
> >> incon-degr-cmd "echo '!DRBD! pri on incon-degr' | wall ; sleep 60 ;
> >> halt -f";
> >>
> >> startup {
> >> degr-wfc-timeout 120; # 2 minutes.
> >> }
> >>
> >> disk {
> >> on-io-error panic;
> >> }
> >>
> >> net {
> >> timeout 60; # 6 seconds (unit = 0.1 seconds)
> >> connect-int 10; # 10 seconds (unit = 1 second)
> >> ping-int 10; # 10 seconds (unit = 1 second)
> >> on-disconnect reconnect;
> >>
> >> }
> >>
> >> syncer {
> >> rate 150M;
> >> }
> >>
> >> on silvana {
> >> device /dev/drbd0;
> >> disk /dev/sdb5;
> >> address 10.0.0.7:7788;
> >> meta-disk /dev/sda2[0];
> >> }
> >>
> >> on franciele {
> >> device /dev/drbd0;
> >> disk /dev/hdc5;
> >> address 10.0.0.40:7788;
> >> meta-disk /dev/hda2[0];
> >> }
> >>}
> >>
> >>
> >>resource franciele-named {
> >> protocol B;
> >> incon-degr-cmd "echo '!DRBD! pri on incon-degr' | wall ; sleep 60 ;
> >> halt -f";
> >>
> >> startup {
> >> degr-wfc-timeout 120; # 2 minutes.
> >> }
> >>
> >> disk {
> >> on-io-error panic;
> >> }
> >>
> >> net {
> >> timeout 60; # 6 seconds (unit = 0.1 seconds)
> >> connect-int 10; # 10 seconds (unit = 1 second)
> >> ping-int 10; # 10 seconds (unit = 1 second)
> >> on-disconnect reconnect;
> >>
> >> }
> >>
> >> syncer {
> >> rate 150M;
> >> }
> >>
> >> on silvana {
> >> device /dev/drbd1;
> >> disk /dev/sdb6;
> >> address 10.0.0.7:7789;
> >> meta-disk /dev/sda2[1];
> >> }
> >>
> >> on franciele {
> >> device /dev/drbd1;
> >> disk /dev/hdc6;
> >> address 10.0.0.40:7789;
> >> meta-disk /dev/hda2[1];
> >> }
> >>}
> >>
> >>
> >>resource franciele-mysql {
> >> protocol B;
> >> incon-degr-cmd "echo '!DRBD! pri on incon-degr' | wall ; sleep 60 ;
> >> halt -f";
> >>
> >> startup {
> >> degr-wfc-timeout 120; # 2 minutes.
> >> }
> >>
> >> disk {
> >> on-io-error panic;
> >> }
> >>
> >> net {
> >> timeout 60; # 6 seconds (unit = 0.1 seconds)
> >> connect-int 10; # 10 seconds (unit = 1 second)
> >> ping-int 10; # 10 seconds (unit = 1 second)
> >> on-disconnect reconnect;
> >>
> >> }
> >>
> >> syncer {
> >> rate 10M;
> >> }
> >>
> >> on silvana {
> >> device /dev/drbd2;
> >> disk /dev/sdb7;
> >> address 10.0.0.7:7790;
> >> meta-disk /dev/sda2[2];
> >> }
> >>
> >> on franciele {
> >> device /dev/drbd2;
> >> disk /dev/hdc7;
> >> address 10.0.0.40:7790;
> >> meta-disk /dev/hda2[2];
> >> }
> >>}
> >>====================
> >>
> >>Thanks
> >>
> >>Flávio Caetano
> >>_______________________________________________
> >>drbd-user mailing list
> >>drbd-user at lists.linbit.com
> >>http://lists.linbit.com/mailman/listinfo/drbd-user
--
-------------------------------