Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
Thanks Alex, > -----Original Message----- > From: drbd-user-bounces at lists.linbit.com > [mailto:drbd-user-bounces at lists.linbit.com]On Behalf Of Alex Haye > Sent: Sunday, 7 August 2005 5:18 PM > To: DRBD List > Subject: Re: [DRBD-user] DRBD and heartbeat IP config. > > > On 8/7/05, David <david at davidbranford.net> wrote: > > Hi all, > > > > I'm currently investigating how to configure DRBD to work with heartbeat > > between 2 PC's (I have a drbd resource, r0, working successfully). > > > > My confusion at the moment: should the IP address which drbd > uses be failed > > over, or should it be configured via the standard system > network scripts? > > (running RedHat 9) > > > > David. > > > If you're looking for a single IP, active/passive configuration > example then I'm pretty sure you want to look at this: > > http://linux-ha.org/GettingStarted_2fOneIPAddress Thanks - have seen that site, but not knowing heartbeat resources config. very well I didn't know how to read the resource lines in haresources properly (have since worked that out). > >From what I can tell, don't rely on your distro to setup the IP. The > "init.d"-like scripts that come with heartbeat will handle assigning > your virtual cluster IP automatically. ok, so do you mean set the network interface that DRBD uses up via the distro. scripts and then assign *only* the virtual IP address via heartbeat? Since the IP addresses of the interfaces DRBD uses need to be hard-coded in drbd.conf I guessed I should set these manually (ie. via the distro. scripts). Does that sound right? Thanks, David. > HTH > > -- > Alex > _______________________________________________ > drbd-user mailing list > drbd-user at lists.linbit.com > http://lists.linbit.com/mailman/listinfo/drbd-user > > !DSPAM:42f5bcd0173974605516295! > >