Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
On Thursday 30 September 2004 15:46, Luca Uburti wrote: > This is my first post to this ML, I hope this problem > has not been already discussed here, but I couldn't > find a solution elsewhere. > > I installed drbd 0.7.4 + heartbeat rpm's for RH8 from > UltraMonkey + ipfail. > > I set up a cluster of two computers: node1 (primary) > and node2 (secondary), sharing the drbd device on the > net with Samba. Each node has two Nic's, one for the > data and one for the heartbeats on a crossover cable. > > Everything seems to work fine except for one thing. > > Whenever I disconnect the eth cable from node1 (the > "data" cable, not the heartbeat cable), node1 becomes > secondary and node2 becomes primary, BUT if I later > reconnect this cable, the node2 prints this message in > the logs: I think you got the heartbeat config not right. There should not be any failover/switchover/failback process happening if you only interrupt the "data" link. -Philipp -- : Dipl-Ing Philipp Reisner Tel +43-1-8178292-50 : : LINBIT Information Technologies GmbH Fax +43-1-8178292-82 : : Schönbrunnerstr 244, 1120 Vienna, Austria http://www.linbit.com :