Note: "permalinks" may not be as permanent as we would like,
direct links of old sources may well be a few messages off.
/ 2004-07-30 23:29:30 +0200 \ Lars Ellenberg: > / 2004-07-30 16:34:32 -0400 > \ Tim Tregubov: > > Heya - > > > > Same problem here! > > > > With a 3ware SATA Raid with 7 Maxtor 7Y250M0 drives. > > > > With scp rates are about 25MB/s (from machine1 raid to machine2 > > raid(without drbd)) > > with netcat up to 30MB. (from file on machine1 raid to file on > > machine2 raid(without drbd)) > > > > Bonnie shows good performance on the HD's themselves. > > > > > > BUT: > > > > [root at topdog root]# cat /proc/drbd > > version: 0.7.0 svn $Rev: 1438 $ (api:74/proto:74) > > > > 0: cs:SyncSource st:Secondary/Secondary ld:Consistent > > ns:268888 nr:0 dw:0 dr:272000 al:0 bm:16 lo:0 pe:563 ua:778 ap:0 > > [===================>] sync'ed: 99.9% (1058590/1058850)M > > finish: 68:26:02 speed: 4,396 (4,937) K/sec > > if you use anything before this revision: > > | r1451 | lars | 2004-07-23 16:18:42 +0200 (Fri, 23 Jul 2004) | 1 line > | Changed paths: > | M /trunk/drbd/drbd_proc.c > | > | fix integer overflow in progress bar > > (and you do: 0.7.0 tgz is 1438 or 1439) > > it may just deisplay the wrong value... > please verify that by a grep in syslog: > grep -E "Resync (started|done)" /tmp/2004-07-*/screenlog.1 > and do the calculation yourself, based on the timestamp and the amount > announced on start. > > just an idea... if its not that, then try to set the rate to some large figure (100M or something) the syncer in drbd 0.7.0 follows a weird timer based pattern, which I personally dislike, but in our test environments it did work... Lars Ellenberg -- please use the "List-Reply" function of your email client.