<p dir="ltr"><br>
On 25/02/2016 7:47 PM, "Eric Robinson" <<a href="mailto:eric.robinson@psmnv.com">eric.robinson@psmnv.com</a>> wrote:<br>
><br>
> I have a 2-node cluster, where each node is primary for one drbd volume and secondary for the other node’s drbd volume. Replication is A->B for drbd0 and A<-B for drbd1. I have a logical volume and filesystem on each drbd device. When I try to failover resources, the filesystem fails to mount because lvdisplay shows the logical volume is listed as “not available” on the target node. Is there some trick to getting LVM on DRBD to fail over properly?<br>
><br>
> <br>
><br>
> --<br>
><br>
> Eric Robinson<br>
><br>
> <br>
><br>
> <br>
><br>
><br>
> _______________________________________________<br>
> drbd-user mailing list<br>
> <a href="mailto:drbd-user@lists.linbit.com">drbd-user@lists.linbit.com</a><br>
> <a href="http://lists.linbit.com/mailman/listinfo/drbd-user">http://lists.linbit.com/mailman/listinfo/drbd-user</a><br>
><br>
And your pacemaker config is??? Run<br>
# crm configure show<br>
and paste it here.</p>