<div>
Hello,<br> Thank you for reply.<br> So if I good understand is it possible to add more than one disk to one resource?<br> <br> Best regards<br>
<blockquote style="border-left:solid #1010ff 2px; margin-left:5px; padding-left:5px;">----- Original Message -----<br>
From: Lars Ellenberg <lars.ellenberg@linbit.com><br>
To: drbd-user@lists.linbit.com<br>
Subject: Re: [DRBD-user] Write ordering in DRBD 8.4<br>
Date: Sat, 27 Oct 2012 11:25:28 +0200<br>
<br>
<br>
On Wed, Oct 24, 2012 at 01:19:03PM +0200, Adrian Berlin wrote:<br>
> Hello,<br>
><br>
> Can anyone explain more about write-ordering in a single connection?<br>
> Is it enabled by default or I need to enable it in config file?<br>
> How it is working?<br>
<br>
All volumes share the same TCP connection for replication.<br>
Incoming changes on all volumes of one resource are send via that <br>
single connection.<br>
TCP deliveres packets in order.<br>
<br>
Does that answer your question?<br>
<br>
If not, can you rephrase?<br>
<br>
<br>
--<br>
: Lars Ellenberg<br>
: LINBIT | Your Way to High Availability<br>
: DRBD/HA support and consulting http://www.linbit.com<br>
<br>
DRBD® and LINBIT® are registered trademarks of LINBIT, Austria.<br>
__<br>
please don't Cc me, but send to list -- I'm subscribed<br>
_______________________________________________<br>
drbd-user mailing list<br>
drbd-user@lists.linbit.com<br>
http://lists.linbit.com/mailman/listinfo/drbd-user<br>
</lars.ellenberg@linbit.com></blockquote>
</div>
<BR>
--