Hi all,<br><br>I have a really curious problem here with my drbd-8.0.3 primary/primary setup. After reboot I got the famous split-brain status. Since my config says disconnect for that case (after-sb-2pri disconnect;) , my drbd resource waits for manual handling...
<br><br>Whenever I try to resync I am stuck with the following status on both nodes:<br><br>SVN Revision: 2881 build by root@www1, 2007-05-11 00:40:43<br> 0: cs:WFBitMapS st:Secondary/Secondary ds:UpToDate/UpToDate C r---
<br> ns:0 nr:0 dw:0 dr:0 al:0 bm:34 lo:0 pe:0 ua:0 ap:0<br> resync: used:0/31 hits:0 misses:0 starving:0 dirty:0 changed:0<br> act_log: used:0/127 hits:0 misses:0 starving:0 dirty:0 changed:0<br><br>Doesn´t matter if i bring up secondary/secondary or primary/secondary or any other combination :-(
<br><br>The DRBD wiki says the connection status WFBitMap is just a " Transitory state when synchronization starts; "dirty"-bits are exchanged." . So i thought after sucessful resync "UptoDate/UptoDate" everything is fine. But this is not happening. Anyone knows what is going on here ? Is primary/primary setup too experimental and not recommended for usage ?
<br><br>I als tried he solution postes a while back by Lars for doing a manual resync, but no go. drbdadm always quits with unknown error 0 (or so). And yes, i know the drives should be disconnected for that.<br><br>node0: drbdadm connect all
<br>node1: drbdadm -- --discard-my-data connect all<br><br>Thanks for your time and keep up the good work !<br><br><br>Luan Nguyen<br><br>